Unpacking And Installing The Printer - Oki B412dn User Manual

Unpacking and Installing the Printer

This section describes how to unpack and install the printer.
Note
Use extra care when handling the image drum (the green cylinder), because it is fragile.
Do not expose the image drum to direct sunlight or strong light (approximately 1,500 lux or more). Even under room lighting,
when leaving the image drum for 5 minutes or more, put sheets of paper over it to shield it from the light. Even with sheets of
paper put over the image drum, do not leave it for 1 hour or more.
If the toner cartridge is not secured correctly, printing quality may decline.
If [TONER LOW] remains displayed on the operator panel even after installing a toner cartridge, set the cartridge again.
First, use the starter toner cartridge that comes with the printer, and after the status becomes [TONER LOW], use a toner
cartridge purchased separately.
If you use a separately-purchased toner cartridge first, you cannot use the starter toner cartridge anymore.
For details on how to feed paper to the printer, refer to
1.
Remove the printer from the box, and then remove cushioning material and the plastic bag from the
printer.
A set of accessories is packed within the cushioning material.
2.
Lift the printer, and then place it where it is to be installed.
3.
Remove the protective tapes on the printer: two on the front side, and one on the rear side.
4.
Remove the sheet of paper on the front side of the printer.
5.
Press the [OPEN] button.
6.
Open the top cover.
"Loading Paper".
438