Saving Power Consumption With The Power Save Function - Oki B412dn User Manual

Saving Power Consumption with the Power Save Function

The printer has three Power Save modes: Power Save, Sleep, and Deep Sleep.
If you do not use the printer for a certain period of time, the printer automatically enters Power Save mode, saving power consumption.
Alternatively, you can switch the printer to Power Save mode by pressing
The procedures for switching the printer to each mode and conditions to exit each mode are shown in the table below.
Power Procedure for switching
Save the machine to each
mode mode
Power After a certain period of
*1
Save time passes , or press
mode (POWER SAVE)
Sleep After a certain period of
*2
mode time passes
Deep After a certain period of
*2
Sleep time passes
mode
*1
If the machine idles for a certain period of time (1 minute by factory default), the machine automatically enters Power Save mode.
To change the time to enter Power Save mode, refer to
*2
If the machine idles for a certain period of time (1 minutes by factorydefault) in Power Save mode, the machine automatically
enters Sleep mode or Deep Sleep mode.
To change the time to enter Sleep mode or Deep Sleep mode, refer to
*3
For details on the applicable function, refer to
*4
For details on the restrictions, refer to
Setting Power Save Mode
This section describes how to set Power Save mode.
Setting Sleep Mode
This section describes how to set Sleep mode and exit Sleep mode to the standby status.
About Restrictions in Sleep Mode and Deep Sleep Mode
This section describes the restrictions of the printer driver, utility and the network functions that arise when the printer enters Sleep
Mode or Deep Sleep Mode.
Condition to Machine status
switch to
each mode
- The backlight on the operator panel turns
off. (POWER SAVE) lights up in
green.
A certain The screen on the operator panel turns
*3
function is off. (POWER SAVE) flashes in green
enabled.
(every 3 seconds).
A certain The screen on the operator panel turns
*3
function is off. (POWER SAVE) flashes in green
disabled.
(every 6 seconds).
"Setting Power Save
"Setting Sleep Mode".
"About Restrictions in Sleep Mode and Deep Sleep
191
(POWER SAVE).
Condition to exit each mode
Press a button on the operator
panel. Print data, or other data is
received.
Press
data, or other data is received.
Same conditions as Sleep mode are
applied or there are restrictions to
exit Deep Sleep
Mode".
"Setting Sleep Mode".
Mode".
(POWER SAVE). Print
*4
.