Garmin G1000 Pilot's Manual page 5

DCLTR (declutter) – pressing the DCLTR softkey
removes map information in three levels.
CHKLIST (checklist) – pressing the CHKLIST
softkey displays the Checklist Page.
ELECTRONIC CHECKLISTS
The G1000 Multi Function Display installed in the
Cessna Nav III provides checklists which allow a pilot
to quickly find the proper procedure on the ground and
during each phase of flight.
NOTE: The checklist information described in this
section is not intended to replace the checklist
information described in the Nav III Information
Manual and the Pilot Safety and Warning Supple-
ments document.
NOTE: Garmin is not responsible for the content
of the checklists. User-defined checlists are cre-
ated by the aircraft manuafacturer. Additionally,
modifications or updates to the checklists are
corrdinated through the aircraft manaufacturer.
The user cannot edit the checklists.
Displaying the Checklist Page
The Power-up Page displays the current checklist file
that is installed for the NAV III aircraft. If no checklist
is present, then the Power Up Page displays the text
"CHECKLIST FILE NOT PRESENT" and the CHKLIST
softkey is greyed out.
To select the Checklist Page:
1. From any page, press the CHKLIST softkey.
190-00392-02 Rev. A
Selecting a Procedure Group
number of groups of procedures with their respective
checklists available to the pilot.
Selecting a Checklist within the Procedure
Group
Selecting a Checklist Item
pressing the ENT key; or (2) pressing the DONE softkey.
(1) Pressing the ENT key:
or small FMS knob to move up and down the checklist
and highlight an item with a hollow white rectangle. The
default color for non-selected checklist items is blue and
once the item is highlighted, the color turns white. To
select a checklist item that is highlighted, press the ENT
key. The selected item turns green in color again for ease
of identification, and then a checkmark is placed in the
box next to the item. As an item is selected, the next item
is automatically highlighted for selection. (2) Pressing the
DONE Softkey: Pressing the DONE softkey produces the
same results as pressing the ENT key.
Garmin G1000 MFD Pilot's Guide for Cessna Nav III
Depending on the specific airframe, there are a certian
To select a procedure group:
1. Press the softkey.
CHKLIST
2. Turn the large FMS knob to select the 'GROUP'
field.
3. Turn the small FMS knob to select the desired
procedure and press the ENT key.
1. Turn the large FMS knob to select the 'Checklist'
field.
2. Turn the large or small FMS knob to select the
desired checklist and press the ENT key.
Two methods are available to select a checklist item: (1)
With the desired checklist displayed, turn the large
INTRODUCTION
8A-3