Garmin G1000 Pilot's Manual page 44

DIRECT-TO NAVIGATION
DIRECT-TO NAVIGATION OPERATIONS
Selecting a Direct-to Waypoint
In addition to selecting a Direct-to waypoint using
an identifier, a Direct-to waypoint can be selected in the
following ways:
• by facility or city name
• from the active flight plan
• from the nearest airports list
• from a waypoint field, waypoint page, or map
highlight shortcut
Selecting a Direct-to Destination by Facility or City
Name
In addition to selecting a destination by identifier, the
Direct-to Page also allows the selection of airports, VORs
and NDBs by facility or city name. If duplicate entries
exist for the entered facility or city name, additional entries
can be viewed by continuing to turn the small FMS knob
during the selection process.
8A-42 Garmin G1000 MFD Pilot's Guide for Cessna Nav III
To select a Direct-to destination by facility
name or city:
Press the Direct-to key. The Direct-to Page is
1.
displayed with the waypoint identifier field
highlighted.
2. Turn the large FMS knob to highlight the facility
or city name field.
Turn the small and large FMS knob to enter
3.
the facility or city location of the desired
waypoint.
NOTE: the "Spell N Find" feature selects the first
entry in the database based on the characters
that have been entered to that point.
4. Continue turning the small FMS knob to scroll
through any additional database listings for
the selected facility name or city. The small
FMS knob can be used to scroll backwards if
the desired waypoint was passed up.
5. Press the ENT key to confirm the selected
waypoint, and ENT again to activate a Direct-
to.
190-00392-02 Rev. A