Garmin G1000 Pilot's Manual page 134

AUXILIARY PAGE GROUP
GPS Signal Strength
The Satellite Status Page can be helpful in
troubleshooting weak (or missing) signal levels due to poor
satellite coverage or installation problems. Refer to this
page occasionally to monitor GPS receiver performance
and establish a normal pattern for system operation.
Should problems occur at a later date, it may be helpful to
have an established baseline from which to compare.
As the GPS receiver locks onto satellites, a signal
strength bar is displayed for each satellite in view, with
the appropriate satellite number (01-32) underneath each
bar. The progress of satellite acquisition is shown in three
stages:
• No signal strength bars - the receiver is looking
for the satellites indicated.
• Hollow signal strength bars - the receiver has
found the satellites and is collecting data.
• Solid signal strength bars - the receiver has
collected the necessary data and the satellites are
ready for use.
• Checkered signal strength bars - the receiver has
excluded the satellite (FDE).
8A-132
Figure 8A.9.8 GPS Signal Strength
Garmin G1000 MFD Pilot's Guide for Cessna Nav III
To select the GPS receiver for which data is
displayed:
1. Select the GPS Status Page.
Press the GPS1 softkey for the display of infor-
2.
mation pertaining to GPS1 or press the GPS2
softkey for the display of information pertaining
to GPS2.
190-00392-02 Rev. A