Garmin G1000 Pilot's Manual page 139

The Display Units section of the System Setup Page
allows the following operations:
• To select a Nav Angle (auto, true)
• To select Distance and speed units (metric or
nautical)
• To select Altitude and vertical speed units (feet,
meters)
• To select Barometric pressure units (inches of
mercury, hectopascals)
• To select Temperature units (Celsius, Fahrenheit)
• To select Fuel and fuel flow units (gallons, impe-
rial gallons, kilograms, liters, pounds)
To change a Display Units setting:
1. Select the System Setup Page.
2. Press the FMS knob momentarily, to activate
the flashing cursor.
Turn the large FMS knob to highlight the
3.
desired 'DISPLAY UNITS' field.
Turn the small FMS knob to display the options
4.
list for the selected item.
5. Turn the small or large FMS knob to highlight
the new selection.
Press the ENT key.
6.
190-00392-02 Rev. A
Map Datums
selection of map datums to be used by the G1000 from a
list of datums available in the current aviation database
(See Appendix D for a list of available map datums).
NOTE: Per TSO C129a, the WGS-84 map datum should
be used in the United States. For use outside the U.S.,
select the geodetic datum required by that country.
Garmin G1000 MFD Pilot's Guide for Cessna Nav III
AUXILIARY PAGE GROUP
The Map Datum section of the System Setup Page allows
To select a Map Datum:
1. Select the System Setup Page.
Press the FMS knob momentarily, to activate
2.
the flashing cursor.
3. Turn the large FMS knob to highlight the
desired 'MAP DATUM' field.
Turn the small FMS knob to display the Map
4.
Datum list.
5. Turn the small or large FMS knob to highlight
the new datum.
Press the ENT key.
6.
8A-137