Canon imagePROGRAF iPF5000 Series Service Manual page 187

Display
position
21
22
23
24
25
26
27
28
29
30
31
32
c) ADJUST
Performs adjustments and prints the adjustment and check patterns necessary for adjusting the printer parts.
- PRINT PATTERN > NOZZLE 1
1. This nozzle check pattern is used during servicing and is printed in the single direction using a single path. It is used to check for nozzles that are not injecting
ink properly.
This pattern is printed on A4-size media in the landscape orientation.
The media type is optional.
- PRINT PATTERN > OPTICAL AXIS
This pattern is used to adjust the registration sensor optical axis. For details, refer to "Disassembly/Adjustment" > "Adjustment and Setup" > "Action to Take after
Replacing the Carriage Unit or Multi Sensor".
Use photo glossy paper.
- PRINT PATTERN > LF TUNING
This pattern is used to adjust the cassette feed roller eccentricity. For details, refer to "Disassembly/Adjustment" > "Adjustment and Setup" > "Action to Take after
Replacing the Cassette Feed Roller HP Sensor or Cassette Feed Roller Encoder".
Use photo glossy paper.
- PRINT PATTERN > LF & HAKUSYA
This pattern is used to adjust the LF pinch roller and spur.
LF & HAKUSYA is dedicated to the adjustment in the factory. This adjustment is not required during servicing
- HEAD ADJ.
This mode allows you to set or reset the registration adjustment values of individual heads.
Display
AUTO HEAD ADJ
MNUAL HEAD ADJ
ADJ. SETTING
RESET SETTING
- NOZZLE CHK POS.
This mode allows you to adjust the optical axis of the head management sensor. For details, refer to "Disassembly/Adjustment" > "Adjustment and Setup" > "Action
to Take after Replacing the Head Management Sensor".
- GAP CLIB.
This mode measures the gap between the head and media using a multi sensor and updates the calibration value.
- SENSOR CALIB.
This mode adjusts the sensor for color calibration. Use a dedicated test chart.
- CHANGE LF TYPE
This mode allows you to change the LF roller type.
0: Old roller
1: New roller
d) REPLACE
Used when replacing the cutter unit. For details, refer to "Disassembly/Adjustment" > "Adjustment and Setup" > "Precautions for Disassembly/Adjustment" > "Cut-
ter".
e) FUNCTION
Checks the operation of the buttons on the operation panel and printer parts.
Sensor name LCD display contents
Cutter Hp Sensor 0: Sensor ON , 1: Sensor OFF
(Not Used) -
(Not Used) -
(Not Used) -
(Not Used) -
Roll unit detection 0: Roll unit not detected , 1: Roll unit detected
Cutter unit detection 0: Cutter unit not detected , 1: Cutter unit detected
(Not Used) -
(Not Used) -
(Not Used) -
(Not Used) -
(Not Used) -
Description
Prints and reads (adjusts) the auto head adjustment pattern.
ROUGH: Enlargement and rough adjustment
Prints the manual head adjustment pattern.
DETAIL: Fine adjustment
BASIC: Simple adjustment
Allows you to enter any registration adjustment value within the range of -127 to +127.
Resets the registration adjustment values.
Adjustment values A1 to F* are reset (to zeros).
T-7-7
Chapter 7
7-7