System Switch 03 (Sp No. 1-101-004); System Switch 04 (Sp No. 1-101-005) - Ricoh D117 Service Manual

Bit Switches
Memory read/write by RDS
Bit 7 Bit 6
0 0
0 1
6-7
1 0
1 1
No Function
Length of time that RDS is
0
temporarily switched on when
to
bits 6 and 7 of System Switch
7
02 are set to "User selectable"
No Function
0-2 Not used
Printing dedicated tx
parameters on Quick/Speed
3 Dial Lists
0: Disabled
1: Enabled
4-7 Not used
D649
(0,0): All RDS systems are always locked out.
(0,1), (1,0): Normally, RDS systems are locked
Setting
out, but the user can temporarily switch RDS
on to allow RDS operations to take place. RDS
Always disabled
will automatically be locked out again after a
User selectable
certain time, which is stored in System Switch
03. Note that if an RDS operation takes place,
User selectable
RDS will not switch off until this time limit has
Always enabled
expired.
(1,1): At any time, an RDS system can access
the machine.

System Switch 03 (SP No. 1-101-004)

00 - 99 hours (BCD).
This setting is only valid if bits 6 and 7 of
System Switch 02 are set to "User selectable".
The default setting is 24 hours.

System Switch 04 (SP No. 1-101-005)

Do not change these settings.
1: Each Quick/Speed dial number on the list is
printed with the dedicated tx parameters (10
bytes each).
The first 10 bytes of data are the programmed
dedicated tx parameters; 34 bytes of data are
printed (the other 24 bytes have no use for
service technicians).
Do not change these settings.
Comments
Comments
64 SM