Communication Switch 12 (Sp No. 1-104-019); Communication Switch 14 (Sp No. 1-104-021) - Ricoh D117 Service Manual

Bit Switches
Communication Switch 11 – Not used (do not change the settings.)

Communication Switch 12 (SP No. 1-104-019)

No Function
Memory transmission: Interval
0-7 between dialing attempts to the
same destination
Communication Switch 13 – Not used (do not change the settings.)

Communication Switch 14 (SP No. 1-104-021)

No
Inch-to-mm conversion during
0 transmission
0: Disabled, 1: Enabled
1-5 Not used
D649
01 – FF (Hex) minutes
Function
Comments
Comments
0: In immediate transmission, data
scanned in inch format are transmitted
without conversion.
In memory transmission, data stored in
the SAF memory in mm format are
transmitted without conversion.
Note: When storing the scanned data
into SAF memory, the fax unit always
converts the data into mm format.
1: The machine converts the scanned
data or stored data in the SAF memory
to the format which was specified in the
set-up protocol (DIS/NSF) before
transmission.
Do not change the factory settings.
98 SM