Speed Mode; Print Mode; Paper Mode - Minolta Magicolor 3100 Series Service Manual

Recording system:
Fuser fan:
Rear fan:
N Ready mode
Ready state
Fixing system:
Exposure system:
Recording system:
Fuser fan:
Rear fan:
*1: Can be changed ready temperature status from the controller.
*2: Can be changed operation status from the controller.
*3: Fan status is changed depending on the state (temperature, etc.) of the fixing system.

4.7 Speed Mode

Speed mode of the printer san be switched over between full-speed mode (printing at the highest
processing speed of the printer) and half-speed mode (printing at the half-speed processing mode). The
controller cannot instruct to change the speed mode.

4.8 Print Mode

Standard mode, fine mode and high gross mode are available for the printer. Mode is switched by the
instruction from the controller. The high gross mode can be selected only for the plain paper, 600psi.

4.9 Paper Mode

11 paper modes are available for this printer. Modes are switched over under the instruction from the
controller.
Classification of paper mode
(1) Plain paper L mode
(2) Plain paper H mode
(3) Woodfree paper L mode
(4) Woodfree paper H mode
(5) Thick paper L mode
(6) Thick paper H mode
(7) Label L mode
(8) Label H mode
(9) OHP mode
(10) Envelope mode
(11) Postcard mode
Relation between the resolution, speed mode, print mode and paper mode is shown in the table below.
8-408
Operating status
Operating at high speed
Operating at high speed
Stop status *1
Stop status *2
Stop status
Stop status *3 (half-speed running)
Stop status *3 (half-speed running)