Minolta Magicolor 3100 Series Service Manual page 174

RRP3.18 SOLENOID FEED (PL3.3.16)
Removal
1) Pull out the CASSETTE from the printer.
2) Remove the COVER TOP MAIN. (RRP1.4)
3) Remove the COVER SIDE L. (RRP1.14)
4) Remove the COVER SIDE R. (RRP1.9)
5) Remove the CHUTE ASSY TURN. (RRP3.1)
6) Remove the LINK ACTUATOR (RRP 3.17).
7) Remove the COVER CASSETTE REAR. (RRP3.2)
8) Remove the FEEDER ASSY UNIT. (RRP3.3)
9) Remove the PICKUP ASSY. (RRP3.12)
10) Remove 1 screw securing the SOLENOID FEED from the PICKUP ASSY (PL3.3.1).
11) Separate the SOLENOID FEED a little from the PICKUP ASSY and shift the harness of the
SOLENOID FEED.
12) Remove the connector (P/J474) of the SOLENOID FEED from the PICKUP ASSY.
Replacement
Replace the components in the reverse order of removal.
3-172
Figure: SOLENOID FEED Removal