Minolta Magicolor 3100 Series Service Manual page 181

HOLDER ASSY RETARD
Removal
1) Release the latch at A from the printer and open the FRONT ASSY IN (PL5.1.1).
2) Push back the rear edge of the HOLDER ASSY RETARD from the HOUSING ASSY RETARD
(PL4.1.1) of the printer, and turn the HOLDER ASSY RETARD to the rear.
3) Sliding the HOLDER ASSY RETARD rightward, pull the left shaft of HOLDER ASSY RETARD out of
the bearing bore in the HOUSING ASSY RETARD.
4) Pull out the HOLDER ASSY RETARD to left upward from the HOUSING ASSY RETARD.
5) Release the hook at 1 position securing the SHAFT RTD (PL4.1.3) to the HOLDER ASSY RETARD of
the printer.
6) Raise the SHAFT RTD to right upward, and pull out the ROLL ASSY RETARD.
Replacement
Replace the components in the reverse order of removal.
ROLL ASSY RETARD
Figure: ROLL ASSY RETARD Removal (3)
Chapter 3 Removal and Replacement Procedures
3-179