York YHGS Installation Instructions Manual page 14

Preparing the outdoor unit
While the outdoor section remains on the pallet it should be
prepared for placing on the stand. Carry out the following:
3. There are three M6x20 screws on the lower edge of the outdoor
unit. Unscrew them so that 2-3 mm of the thread remains. Use
a torx TX25 screwdriver, or equivalent.
4. Raise the outdoor unit. NOTE! Do not lift the side plates.
5.
Remove the side plates. They are held in place by clamps and
so are removed by pulling outwards.
6.
Remove all four screwed lifting eyes. Use a 13 mm wrench, or
equivalent.
Preparing the outdoor unit
Figure 22: Lift the outdoor unit onto the stand.
7.
Lift the outdoor unit into the place on the stand.
8.
Screw the outdoor unit onto the stand. Use 4 x M6x20 screws.
It may be necessary to push and pull the stand slightly in order
to get the screw holes to align.
NOTE! When filling the brine system the outdoor unit
!
must be bled using the bleed screws on the connecting
pipes inside the side covers. We recommend that you
return to this instruction after the brine system has
been filled.
9.
Reinstall the side panels.
Assembling the front cover
10.
Hook the lower edge of the front cover onto at least one of the
three screws in the bottom edge of the stand.
11.
Secure the upper edge of the front panel temporarily in the
centre hole. Use 1 x M6x15 torx TX25.
12.
Align all the three screws in the lower edge.
13.
Screw the three screws in the lower edge fully. Use a torx
TX25 screwdriver, or equivalent.
14. Secure the upper edge of the front cover.
Use only the three screws screwed into the outdoor unit, see figure
below. Use only 3 x M6x15 torx TX25.
14
ENGLISH
Figure 23: Secure the cover.
Assembling the cover and cover plate
15.
Hook the cover at the front edge on the front cover.
Figure 24: Hook the front cover into place.
16. Secure the cover using a screw on each side. Use 2 x cross
head screws.
If the cover does not align with the side cover plates it may be
necessary to drill new Ø 3 mm holes:
Mark for the new holes
l
Lift off the cover
l
Drill the holes
l
Install and screw the cover into place
l
Figure 25: Screw the front cover into place.
17.
Hook the cover onto the stand.
Figure 26: Hook the cover into place.