Configuring System Setup
CONTROL DEVICE TAB
The Control Device tab allows you to configure
PTZ (Pan Tilt Zoom) cameras (sold separately)
on your system. Refer to the PTZ camera's
manual for the proper settings.
For details on connecting your PTZ camera
into the system, see "Appendix F: Connecting
PTZ Cameras" on page 128.
To configure the PTZ protocols:
1. Click the CONTROL DEVICE tab on the left.
• The Control Device window opens.
Figure 14.7 Control Device window.
2. Configure the following:
• SYSTEM ID: Select the desired system ID
(1~254).
• PROTOCOL: Select the protocol used by the
PTZ camera (D-MAX, ZCA-SC201,
MESA-KB, ICK-3000).
• BAUDRATE: Select the baudrate of the PTZ
camera (1200, 2400, 4800, 9600, 19200,
38400, 57600, 115200, 230400)
3. Click APPLY to save your settings.
52