Appendix F: Connecting Ptz Cameras - Lorex LH600 SERIES Instruction Manual

Appendix F: Connecting PTZ Cameras

APPENDIX F: CONNECTING PTZ CAMERAS
You can connect a RS-485 PTZ camera (not included) to the PTZ Control Block on the rear panel
of the system.
Connecting a PTZ camera (not included)
To install a PTZ Camera:
1. Connect the Transmit Cable to the RS-485 D+ (TX+) port of the PTZ block on the rear panel.
2. Connect the Receive Cable to the RS-485 D- (TX-)port of the PTZ block on the rear panel.
3. Connect the video cable to a BNC port (usually channel 1).
4. Open the SYSTEM SETUP menu and select
5. Select PTZ SETUP and configure the ADDRESS, PROTOCOL, and BAUD RATE of your PTZ
camera.
NOTE: The PTZ camera settings depend on the type of PTZ camera. Please refer to the specific camera
manual for your brand and model of PTZ camera.
6. Select APPLY and press ENTER to save your settings.
128
D- (TX-)
D+ (TX+)
VIDEO (BNC)
PTZ CAMERA
(not included)
.
CAMERA
DVR