Device; Configuring Hard Drive Settings; Formatting Usb Flash Drives - Lorex LH010 ECO BLACKBOX SERIES Instruction Manual

Using the Main Menu

Device

The Device menu allows
you to configure hard drive
and PTZ settings and
format a USB flash drive
(not included).
• For details on connecting PTZ cameras
(not included), see "Appendix B:
Connecting a PTZ Camera" on page 112.

Configuring Hard Drive Settings

To format the hard drive:
ATTENTION: Formatting the HDD
on the hard disk. 
all data
erases
This step cannot be undone.
1 Select the HDD tab.
2 Click the checkbox under Select to choose
the drive you wish to reformat.
3 Click Format HDD.
4 When the warning window appears, enter
the admin password (default: 000000) and
click Apply. Wait for the system to format
the hard drive.
To set the hard drive recording mode
(loop recording or linear recording):
1 Select the HDD tab.
2 Select the checkbox beside the hard drive
you wish to configure.
50
3 In the Overwrite drop-down menu, select
Auto. (recommended), or select the
desired duration the hard drive should
retain its data.
NOTE: If overwrite recording is enabled, the
system's hard drive automatically
re-writes the hard drive's oldest
content (first in first out).
4 Click Apply to save your settings.

Formatting USB Flash Drives

ATTENTION: Formatting a USB flash
all data
drive erases
This step cannot be undone.
1 Insert a USB flash drive (not included) into
one of the USB ports on the DVR.
2 In the Main Menu, Device>HDD.
3 Click Format USB, then click OK. Wait for
formatting to complete.
on the drive. 