Table of Contents
Advertisement
Web Remote Viewer
NOTE: To apply changes across all channels, use the ALL drop-down menu.
Use the ALL tab to
apply changes
across all channels.
Figure 23.2 Alarm Input Setting window.
3. Under the Type drop-down menu, select if the alarm is normally open (N/O) or normally
closed (N/C).
4. Click OK to save your settings.
Configuring Alarm Output Settings
To configure alarm output settings:
1. Click the Alarm Output sub-menu on the left navigation bar (Sensor>Alarm Output). The
Alarm Output Setting window opens.
Figure 23.3 Alarm Output window.
2. Under the Operation drop-down menu, select Enable or Disable to turn on or off alarm the
alarm output.
3. Under the Mode drop-down menu, select Latched or Transparent.
• Latched alarms continually "beep" long after a camera detects motion. Transparent alarms
"beep" only when there is motion. Once the camera does not detect motion, the "beeping"
stops.
4. Under the HDD Event drop-down menu, select ON or OFF to enable or disable a hard disk
failure to send out an e-mail notification.
5. For each channel, select which events you want to trigger an alarm (Figure 38.4).
• For example, you may want a video loss and motion event in channel 2 to trigger an alarm.
6. Click OK to save your settings.
92
Advertisement
Table of Contents
