Table of Contents
Advertisement
EVENT/SENSOR
The EVENT/SENSOR tab allows you
to configure how the system
interprets devices connected to the
Alarm block on the rear panel of the system.
Configure HDD events, alarm input/output,
buzzer, and email notifications.
To open the System menu:
1. Right-click anywhere in the main viewing
window.
• The quick-menu opens.
2. Click
• The System Setup menu opens.
3. Click EVENT/SENSOR.
• The Event/Sensor window opens.
Figure 15.0 Event / Sensor window.
HDD EVENT
Use the HDD Event menu to allow the system
to monitor the internal hard disk. If the system
detects a hard drive error, an email is sent to
your email address (email notification must be
configured).
To set HDD event alarms:
1. Beside DISK FULL EVENT, click
select ON or OFF to enable or disable the
system from reporting that the hard drive
is full.
.
to
ALARM INPUT
Use the Alarm Input menu to configure alarm
input types (i.e. motion sensors, not included).
To open the Alarm Input menu:
1. Click the ALARM INPUT tab on the left.
• The Alarm Input window opens.
Alarm Input Tab
Figure 15.1 Alarm Input menu (4-channel model shown).
Make sure you have properly
NOTE:
connected an external alarm device to the
alarm block on the rear panel of the system
prior to configure alarm settings. For more
details, see "Appendix H: Connecting
Motion / Alarm Devices" on page 131.
To configure alarm inputs:
1. Under OPERATION, click
ENABLE.
2. Under TYPE, click
(normally open) or N/C (normally closed).
3. Repeat for the remaining channels.
4. Click APPLY to save your settings.
Refer to your alarm input device's
NOTE:
instructions on how to set the alarm type
(i.e. N/O or N/C).
Configuring System Setup
to select
to select N/O
53
Advertisement
Table of Contents
