Connecting The Cameras; Camera Stand Installation - Lorex LH600 SERIES Instruction Manual

Connecting The Cameras

CONNECTING THE CAMERAS
Before you mount the cameras, test to ensure the cameras have no problems. Plan where you will
route the wiring for the camera, and where you will aim the camera.
Installation Tips
1. Mount the camera where the lenses are away from direct and intense sunlight.
2. Plan your cable wiring so that it does not interfere with power lines or telephone lines.
3. Ensure that the camera wiring is not exposed, or easily cut.
4. Adjust the camera angle so that it covers an area with high traffic.
5. In "high-risk" locations, have multiple cameras point in the same area. This provides camera
redundancy if a camera malfunctions, or if a vandal attempts to damage the camera.
6. Mount the camera in an area that is visible, but out of reach.

CAMERA STAND INSTALLATION

1. Mount the camera stand to the desired mounting surface. Choose a firm mounting surface.
If you wish to mount the camera stand to drywall, it is recommended to use drywall plugs
NOTE:
(not included).
2. Attach the camera to the stand.
*Camera model not be exactly as shown.
Figure 1.0 Camera stand installation.
There are two connection points for certain cameras. Secure the stand to the top thread
NOTE:
for wall-mounts or ceiling mounts. Secure the stand to the bottom thread for table-mounts or
wall mounts.
Table Mount
Figure 1.1 Camera mounting options. Camera model not be exactly as shown.
4
Top thread
(Ceiling mount, Wall mount)
Bottom thread
(Table mount)
Wall Mount
Secure to camera thread
Ceiling Mount