PTZ SETUP TAB
PTZ Setup
Use the PTZ Setup menu to configure any
connected PTZ cameras (not included).
Make sure your PTZ camera is
NOTE:
properly connected to the system prior to
configuring PTZ options. Please refer to
your PTZ camera's instruction manual to
determine the correct settings for your PTZ
camera.
To configure PTZ settings:
1. Click the PTZ SETUP tab on the left.
• The PTZ Setup tab opens.
PTZ Setup tab
Figure 10.3 PTZ Setup menu.
2. Under ADDRESS, select a channel and
click
; select the PTZ address
(1~255).
3. Under PROTOCOL, select the PTZ protocol
using the
button.
• Protocol types: PelcoD, PelcoP
MESA-DOME, D-MAX, Ganz PT ,FastraxII
2, SCC_641, SCC_643a, Spd_3300, Multix,
MRX_1000, Panisonic WV-CS850,
Panisonic WV-csr-604, PTC-400c,
PTC-200, LPT-A100L
4. Under BAUD RATE, click
desired baud rate.
5. Click
Figure 10.4 PTZ property window.
6. In the PTZ Property window, click
7. Click OK to save your settings.
PTZ Property button
to select
• Baud Rate choices: 9600 (default),19200,
38400, 57600, 115200, 230400, 1200, 2400
or 4800,
to open the PTZ property
window.
configure the following PTZ properties:
• Channel Number
• Auto Focus
• Auto Iris
• P/T (pan / tilt) speed
Configuring System Setup
to
41