Upper Cover - Brother DCP130C Service Manual

6.1.7

Upper Cover

NOTE: Make sure that the jam clear cover has been removed.
(1) Open the ink cartridge cover.
(2) Remove the seven screws (six "a" and one "b" screws) from the upper cover.
(3) Insert the tip of a small flat screwdriver into the two openings provided in the front end of the
upper cover, release the upper cover from the bosses on the lower cover, and lift it up.
NOTE: Do not put your hands in the opening above the platen (shown below). Doing so may
damage or stain the CR encoder strip inside.
Peep hole
Upper cover
PF encoder disk
Assembling Notes
• When mounting the upper cover:
- Make sure that the jam clear cover is not mounted.
- Make sure that the head/carriage unit is placed in the head capping position (home position).
This prevents the ink supply tubes from getting crushed between the upper and lower covers.
- Make sure that the ink cartridge cover is opened if the ink cartridge cover sensor actuator has
been mounted. (Mounting the upper cover with the ink cartridge cover being closed will
dislocate the ink cartridge cover sensor actuator.)
- Take care not to deform the PF encoder disk.
- Tighten seven screws
• After mounting the upper cover, check that the PF encoder disk is not bent or deformed through
the peep hole. (See the illustration above.)
Opening above the platen
1
"a"
to
2
"a"
5
7
"a"
"b"
Opening
Boss
Front cover
in this order as shown above.
6-29
Tighten seven screws
in the order of to .
6
3
"a"
"a"
4
"a"
Ink cartridge cover
Lower cover
"a": Taptite, bind B M4x12
"b": Taptite, cup B M3x10
Opening
Boss
Rib
Cover arm
Actuator
lever
(6_30_J)
Confidential