Preparation; How To Access The Target Component - Brother DCP130C Service Manual

Preparation

Prior to proceeding with the disassembly procedure,
(1) Unplug the following:
- Power cord from the electrical outlet
- USB cable, if connected
- LAN cable*, if connected
- USB cable from the PictBridge jack, if connected
(2) Remove the paper tray ASSY.
(3) Remove memory cards if inserted in the machine.
(4) Remove all four ink cartridges and set the protective part instead.

How to Access the Target Component

• On the next page is a disassembly flowchart which helps you access the target components. To
remove the maintenance unit, first find it on the flowchart and note its number (
To access it, you need to remove all the parts above the maintenance unit on the flowchart (
, ,
• Unless otherwise specified, all parts should be replaced in the opposite order to which they were
removed to reassemble the machine.
and in this case) before the unit itself can be removed.
,
Ink cartridge cover
Protective part
6-3
*For wired LAN-enabled models
Paper tray ASSY
(6_01)
Ink cartridges
(6_02)
in this case).
Confidential
,