Brother DCP130C Service Manual page 100

Error Code
(Hex)
5F Not used.
60 Paper width sensor (media
61 sensor) error.
62
63-7D Not used.
7E No head parameters stored
in the EEPROM.
(This code may appear only
in the maintenance mode.)
7F Not used.
80 Not used.
(At the start of FAX
message printing, the
controller detects that
paper is smaller than A4
size in width.)
81 Not used.
82 Recording paper jam in
paper pull-in operation.
(The paper width sensor
fails to detect the leading
edge of paper.)
Symptom
4 - 1 0
Probable Cause
Paper width sensor
defective
Head flat cables broken
Main PCB defective
No head property data
has been entered
Main PCB defective
Paper smaller than the
specified size loaded in
the paper tray
Paper width sensor
defective
Paper width sensor not
adjusted
Main PCB defective
Foreign materials in
the paper path
Paper not loaded
correctly in the paper
tray
Head flat cable
connection failure
Paper width sensor
defective
Main PCB defective
Solution
Replace the carriage PCB
ASSY.
Replace the carriage
PCB ASSY.
Replace the main PCB.
Enter the head property
data.
Replace the main PCB.
Load the correct size of
paper.
Replace the carriage PCB
ASSY.
Adjust the margin for
borderless printing with
Function code 66 in the
maintenance mode.
Replace the main PCB.
Remove foreign
materials.
Reload paper.
Insert the head flat
cables correctly.
Replace the carriage PCB
ASSY.
Replace the main PCB.
Confidential