Brother DCP130C Service Manual page 306

Loading the programs onto the flash ROM of the machine
After replacing the main PCB with a new one
Unplug the power cord of the machine from the electrical outlet and disconnect the USB cable that
connects the machine with your PC.
(1) On your PC, run "filedg32.exe."
The Filedrgs window will appear as shown below.
(2) Connect the machine to your PC using a USB cable.
(3) On the machine, follow the steps below to enter the firmware loading mode.
1) Plug the power cord into an electrical outlet with the
keep holding it down until the following appears on the LCD.
2) Hold down the
Color LCD
(Enlarge/Reduce) key until the following appears on the LCD.
Color LCD
App. 2-5
(Copy Options) key held down and
Monochrome LCD
Monochrome LCD
Confidential