DURKOPP ADLER 906 Service Manual page 95

Maintenance
Installing the inner slider
Figure 69: Installing the inner slider
(4) - Inner slider
(5) - Driver pin
Installation steps
1. Spread the inner slider (4), slide as far as possible into the bracket and
2. Tap the 1 button on the screen.
 The transfer plate is closed.
3. Check that the inner slider is flush with the limit stop (6). Correct the
Service manual 906 - 00.0 - 11/2014
hold it in this position.
Important: The guide drill hole of the slider must be positioned in the
pin of the driver (5). The inner slider must remain fully apart.
position if necessary.
(6) - Stopper
⑥
⑤
④
93