Individual settings
Test the alignment using the semi-finished parts set in exactly the
same way as when using gages, 3.12.1 Check alignment using
gage, page 61. Use the corresponding parts from the semi-finished
parts set instead of the gages when performing testing.
Figure 45: Checking the material feeder alignment – using a semi-finished parts set
(1) - Screws
(2) - Outer frame 0906 410444
(3) - Transfer frame 0906 410434
(4) - Hole
Service manual 906 - 00.0 - 11/2014
①
②
③
④
(5) - Screws
(6) - Locking peg
(7) - Material feeder
⑦
⑥
⑤
63