3.5 Position of the hook and needle
3.5.1 Setting the loop stroke position
The loop stroke is the path length from the bottom dead center of the nee-
dle bar up to the height where the hook tip picks up the loop of thread.
Figure 14: Loop stroke
(1) - Needle
(2) - Groove
The loop stroke is precisely 2 mm.
Order
First check the following settings:
• Needle bar linkage ( 3.4 Aligning the needle bar linkage, page 23)
• A straight and undamaged needle must be inserted
Correct setting
Machine is locked in place at position 1 ( page 18).
The hook tip (3) is precisely at the center of the needle (1).
Fault caused by an incorrect setting
• Missing stitches
Cover
• Raise the upper section ( 3.1.3 Raising the machine upper
24
WARNING
Risk of injury!
Risk of crushing injuries and stab wounds from
moving and sharp parts.
Switch the sewing unit off before checking and set-
ting the loop stroke position.
①
②
③
( Operating instructions section, Inserting and replacing the needle)
section, page 14)
Individual settings
(3) - Hook tip
Service manual 906 - 00.0 - 11/2014