DURKOPP ADLER 906 Service Manual page 56

Setting the cutting pressure
The shape of the thread-pulling knife automatically creates the required
cutting pressure as soon as both cutting edges are on top of one another.
Figure 38: Setting the cutting pressure
(4) - Counter-blade
(5) - Marking
Setting steps
1. Swing out the thread-pulling knife (6) until the marking (5) is next to the
2. Loosen the screw (7).
3. Turn the counter-blade (4) against the thread-pulling knife (6).
4. Tighten the screw (7).
54
④
⑤
cutting edge of the counter-blade (4).
Individual settings
(6) - Thread-pulling knife
(7) - Screw
Service manual 906 - 00.0 - 11/2014
⑦
⑥