DURKOPP ADLER 906 Service Manual page 59

Individual settings
Figure 41: Changing the material presser foot bar II
(6) - Clamp
(7) - Screw
(8) - Strap
5. Position the strap (8) so that the screw (7) is accessible.
6. Undo the screw (7) and take off the strap (8).
7. Pull the sleeve (10) out.
8. Pull the clamp (6) right up to the top and pull the material presser bar (9)
Fitting
1. Fitting is the reverse of removal.
Order
After the drive (1) has been tightened, set the presser foot height
 3.7.5 Setting the presser foot height, page 40.
Service manual 906 - 00.0 - 11/2014
⑥
out upwards.
⑦ ⑧ ⑨ ⑩
(9) - Material presser foot bar
(10) - Sleeve
57