Important
Set the inclination as low as possible. An excessively high inclination can
lead to a collision with the inner slider when the transfer plate transfers the
sewing material.
Set the downforce pressure
The downforce pressure is set via a pressure reducer.
Correct setting
Set the downforce pressure so that the sewing material is held and trans-
ported securely. Set the pressure as low as possible.
Figure 50: Setting the transfer plate downforce pressure
(4) - Rotary knob
(5) - Red marking (rotary knob disengaged)
Setting steps
1. Pull the rotary knob (4) on the pressure reducer (6) upward.
The red marking (5) is visible.
2. Setting the pressure.
3. Checking the setting.
4. Press the rotary knob (4) on the pressure reducer (6) down.
The red marking (5) is no longer visible.
68
The pressure setting is unlocked.
• To increase pressure: Turn the rotary knob (4) clockwise.
• To reduce pressure: Turn the rotary knob (4) counterclockwise.
• Use the foot pedal to raise and lower the transfer plate.
The pressure setting is locked.
The downforce pressure on the transfer plate is set.
Individual settings
(6) - Pressure reducer
Service manual 906 - 00.0 - 11/2014
④
⑤
⑥