10/100/1000 Port Status Led Codes - Symbol WS5000 series Reference Manual

1-6
WS5000 Series Switch System Reference Guide
Table 1.1 System Status LED Codes (Continued)
Event
Configured as a Primary Switch
Active
Monitoring
Standby missing or not enabled
Inactive
Configured as a Standby Switch
Active (acting as primary)
Monitoring
Standby not enabled
Inactive
Error Codes
POST failed (critical error)
Software initialization failed
a
Country code not configured
No access ports have been adopted
Primary inactive or failed
a. During first time setup, the LEDs will remain in this state until the country code is configured.

1.2.3 10/100/1000 Port Status LED Codes

A WS5000 Series Switch includes two indicators for the RJ-45 ports, as follows:
• Upper left (amber/green) for link rate
• Upper right (green) for link activity
Additional information about the status of the 10/100/1000 Port Status LED codes are shown in
Table 1.2 10/100/1000 Port Status LED Codes
LED
Upper left Off
Green steady
Amber steady
Upper right Off
Green steady
Green blinking
Top LED
Blue blinking
Blue blinking
Blue blinking
Amber blinking
Blue blinking
Blue blinking
Blue blinking
Amber blinking
Red blinking
Amber solid
Amber solid
Blue blinking
Amber blinking
State
10 Mbps link rate
100 Mbps link rate
1 Gigabit link rate
The port isn't linked
The port is linked
The port is linked and active
Bottom LED
Blue solid
Amber solid
Off
Blue blinking
Blue blinking
Amber solid
Off
Amber blinking
Red blinking
Off
Amber blinking
Amber blinking
Blue blinking
Table 1.2.
Meaning