Kerberos Configuration Section; Snmp Configuration Section - Symbol WS5000 series Reference Manual

3-6
WS5000 Series Switch System Reference Guide

3.2.4 Kerberos Configuration Section

The Wireless Switch features a built-in Kerberos KDC (Key Distribution Center) for authentication services, a
site may require settings for configuring Kerberos functionality. The settings in the command file for
configuring the KDC include Primary or Slave status, hostname, IP address, realm and domain. When
applicable up to three NTP (Network Time Protocol) servers can be specified. A list of all available Kerberos
actions is included in the command file.
Table 3.4 Kerberos Configuration Section
Option Value
NTPServer1 <NTP xxx.xxx.xx.xx>
<NTP xxx.xxx.xx.xx>
NTPServer2
NTPServer3 <NTP xxx.xxx.xx.xx>
KDCRealm <KDC realm name>
KDCInterface <KDC interface name>
KDCBackupHostname <xxx.xxx.xx.xx>
KDCBackupIP <xxx.xxx.xx.xx>
KDCBackupDomain <server name>
Note All Security Policies which are configured for Kerberos Authentication will automatically
be populated with the Master/Slave/Remote server's IP addresses if present in this file.

3.2.5 SNMP Configuration Section

The SNMP section of the command file contains settings for community attributes and trap actions, that are
used by SNMP-based network management tools to get/set MIB variables in order to configure the Wireless
Switch along with gathering and monitoring device status.
Table 3.5 SNMP Configuration Section
Option
SNMPCommunity[1-4]
SNMPCommunity[1-4]IP
SNMPCommunity[1-4]Perm
Notes
NTP server IP address (for the on-board KDC server). The
primary and standby switches need to be defined with the
same NTP service host to insure that the time source is
consistent.
Second alternate NTP server IP address .
Third alternate NTP server IP address or name.
Kerberos realm name
The interface on which the KDC is configured (1 or 2).
Hostname of the backup slave.
IP address for the backup slave. If this IP address belongs
to any of the Ethernet ports and the hostnames match, the
switch is configured as a slave KDC.
Kerberos Master Hostname where the KDC resides.
Value Notes
<string> This is the SNMP community for the designated group
selection of [1..4]
<ip_address> SNMP community IP address.
<RO | RW permissions>