Modifying A Classification Group - Symbol WS5000 series Reference Manual

Figure 4.13 Creating a Classification Group—Adding Classifiers
4. Select from among the Available Classifiers and then click the >> button to move to the Selected
pane.
5. For each Classifier added to the Selected pane, select an action, as follows
• allow – For classifiers with an allow action, packets that pass through the Classifier are allowed
to continue and they are marked as being part of the Classification Group (this is important, since
Input and Output Policies filter packets based on Classification Groups).
Packets that do not pass the evaluation are not immediately thrown away. They are allowed or
denied according to the default action defined in the Input or Output Policy that uses this
Classification Group.
• deny – Packets that have this action associated with the Classifier are thrown away. Packets that
do not pass are allowed to continue (with no Classification Group marking).
6. When done, click Next. A Classification Group Created Successfully! message panel is displayed.
7. Click Finish to save the new Classification Group and exit the wizard.

4.3.2.2 Modifying a Classification Group

To modify an existing Classification Group, follow these steps:
1. From the WS5000 Series Switch GUI main window, click Modify > Network > Classification Group.
The system launches the Classification Group Manager.
Using the WS5000 Series Switch GUI 4-13