Creating A Security Policy - Symbol WS5000 series Reference Manual

Figure 4.26 Security Policy Where Am I? Dialog Box

4.4.1.1 Creating a Security Policy

To create a security policy, follow these steps:
1. From the WS5000 Series Switch GUI main window, select Create > Access Port > Security Policy.
The Security Policy Wizard appears.
Figure 4.27 Creating a Security Policy—Naming the Policy and Specifying an Encryption Type
2. Enter a name and description for the new Switch Policy.
3. Select one or more encryption methods for the Security Policy. Following are encryption types to choose
from:
• None – No encryption. Any mobile unit that is set to "open" authentication is allowed to associate
with the system unless the adoption list specifically excludes it.
• WEP – 802.11 Wired Equivalent Privacy encryption. If using PSK, WEP must be configured by
choosing 40- or 128-bit encryption and supplying four keys.
• Keyguard MCM – KeyGuard encryption for TKIP (Temporal Key Integrity Protocol). This mode is only
supported by Symbol mobile devices. KeyGuard requires a 128-bit WEP key.
• TKIP – WPA1/WPA2 dynamic encryption. Wi-Fi Protected Access with Temporal Key Integrity
Protocol. If using PSK, an ASCII or hexadecimal value is required to configure TKIP.
Using the WS5000 Series Switch GUI 4-23