Led Codes; Configured As A Primary Switch - Symbol WS5000 Series Installation Manual

4 WS5000 Series: WS5100 Installation Guide
To connect the WS5100 to a computer that's running a serial terminal emulator program
(the "configuration computer"), you need the console cable that's supplied with the
device. You'll use the terminal emulator program to access the switch's Command Line
Interface (CLI) through which you'll perform initial configuration (as described in
"
Preliminary Configuration through the CLI

2.4 LED Codes

The WS5100 has two vertically-stacked LEDs on its front panel. The LEDs display three
colors (blue, amber, and red), and three lit states (solid, blinking, and off). The following
tables decode the combinations of LED colors and states.
2.4.1 Start Up
Event
Power off
Power On Self Test (POST) running
POST succeeded
Software initializing
Software initialized
2.4.2

Configured as a Primary Switch

Event
Active
Monitoring
Standby missing or not enabled
Inactive
2.4.3 Configured as a Standby Switch
Event
Active (acting as primary)
Monitoring
" on page 10).
Top LED
Off
All colors in rotation
Blue solid
Blue solid
Blue blinking
Top LED
Blue blinking
Blue blinking
Blue blinking
Amber blinking
Top LED
Blue blinking
Blue blinking
Bottom LED
Off
All colors in rotation
Blue solid
Off
Off
Bottom LED
Blue solid
Amber solid
Off
Blue blinking
Bottom LED
Blue blinking
Amber solid