Yamaha VX600ERG Service Manual page 95

Ski spindle camber
Place the unit on a level surface and check the ski spindle camber. DO NOT elevate the front end.
1 Using an angle finder, be sure that the unit sits parallel with the floor. Place the angle finder up against the
flat aluminum part of the belly pan.
2 Place the angle finder up against the vertical flat surface on the trailing arm just behind the spindle weld and
check the spindle camber.
Ski spindle camber:
–0.5° to +0.5°
3 To adjust the camber, loosen the lower radius rod ball joint locknut and remove the bolt securing the radius
rod to the trailing arm. Turn the rod in or out as necessary until the proper camber angle is obtained.
FRONT SUSPENSION
Å USE AN ANGLE FINDER TO CHECK THAT THE
UNIT IS LEVEL.
Angle finder:
SEA3340
3-16
CHAS
YS-42422
SEA3350
SEA3360