Yamaha VX600ERG Service Manual page 280

1 Oil pump cable
2 Throttle cable
3 Do not fasten the throttle cable
and oil pump cable.
4 Pass only the throttle, and oil
pump cables through the inside
of the cable holder.
5 Thumb warmer coupler
6 Engine stop switch coupler
7 Connectors of the grip warmer
8 Brake light switch coupler
9 Headlight beam switch coupler
0 Fasten the brake light switch
lead, headlight beam switch lead
and grip warmer leads with a
plastic band.
A Parking brake cable
B Oil tank breather hose
C Fasten the oil tank breather hose
with a plastic band.
D Fasten the wire harness, and the
oil tank breather hose behind the
steering column, with a plastic
band. Do not fasten the parking
brake cable and brake hose.
E Fasten the wire harness and fuel
tank breather hose with a plastic
band, and make sure that the
band's end faces downward.
F Fuse box (VX600ER/VT600)
G Condenser coupler (SX600/
MM600)
H Ground lead
I Fuel sender coupler
J Oil level switch coupler
K Fuel tank breather hose
L Fasten the fuel tank breather
hose, rectifier/regulator leads,
CDI unit harness and ground lead
with a plastic band.
M Fuel hose
N Fasten the fuel hose clip so that it
faces outward.
CABLE ROUTING
9-34
SPEC