Electrical; Headlight Beam Adjustment - Yamaha VX600ERG Service Manual

HEADLIGHT BEAM ADJUSTMENT

ELECTRICAL

HEADLIGHT BEAM ADJUSTMENT
1. Place the machine on a level surface.
2. Place the machine in front of a wall at the recom-
mended distance D. Refer to the table below.
3. Measure the distance H from the floor to the
SEA2670 center of the headlight and place a mark on the
wall at that height.
4. With a person sitting on the machine, apply the
parking brake, start the engine and let it idle.
5. Switch on the headlight's high beam and check
the height of the projected beam on the wall. The
projection should be at the position marked in
step 3 or 1/2° lower (set range S).
D
S
D: Distance
6. Adjust:
•
SEA2675
7. Adjust:
•
2-35
INSP
ADJ
3.0 m (10 ft)
26 mm (1.0 in)
S: Set range
Headlight beam (vertically)
Vertical adjustment
Turn the adjusting screw 1 + 2
Higher
clockwise.
Turn the adjusting screw 1 + 2
Lower
counterclockwise.
Headlight beam (horizontally)
Horizontal adjustment
Turn the adjusting screw 1
To right
clockwise or turn the adjusting
screw 2 counterclockwise.
Turn the adjusting screw 2
To left
clockwise or turn the adjusting
screw 1 counterclockwise.
7.6 m (25 ft)
66 mm (2.6 in)