Yamaha VX600ERG Service Manual page 270

D Connectors of the gear position
switch (VX600ER/VT600)
E Route the main switch wire
harness under the oil tank
breather hose and fuel tank
breather hose.
F Install the main switch coupler
behind the instrument panel.
G Make sure that the main switch
wire harness is on the inside of
the instrument panel screw (away
from the engine).
H Route the parking brake cable
under the oil tank breather hose.
I Make sure that the brake hose
passes over the oil pump and
throttle cables and through the
right side of the hose guide.
(VX600ER/VT600)
J Oil pump cable (VX600ER/
VT600)
K Throttle cable (VX600ER/VT600)
L Oil level switch
M Variable resistor couplers
N Fuse box (VX600ER/VT600)
O Route the oil pump and throttle
cables in the groove of the intake
silencer and route the throttle
cable above the oil pump cable.
(VX600ER/VT600)
P Carburetor heating lever
Q Coolant hose
R Speedometer cable
S Under 50 mm (1.97 in)
T Fasten the speedometer cable
and wire harness with a plastic
clamp. Install the clamp as close
to the drive V-belt guard bracket,
as possible (rearward).
CABLE ROUTING
9-24
SPEC