Electronic Sway Bar Disconnect - If Equipped - Jeep 2016 Wrangler Owner's Manual

460 STARTING AND OPERATING
To activate the system, push the bottom of the AXLE
LOCK switch once to lock the rear axle only (the "Rear
Axle Lock Indicator Light" will illuminate), push the
bottom of the switch again to lock the front axle (the
"Front Axle Lock Indicator Light" will illuminate). When
the rear axle is locked, pushing the bottom of switch
again will lock or unlock the front axle.
NOTE: The indicator lights will flash until the axles are
fully locked or unlocked.
To unlock the axles, push the top of the AXLE LOCK
switch.
Axle lock will disengage if the vehicle is taken out of 4L
(Low) range, or the ignition switch is turned to the OFF
position.
ELECTRONIC SWAY BAR DISCONNECT — IF
EQUIPPED
Your vehicle may be equipped with an electronic discon-
necting stabilizer/sway bar. This system allows greater
front suspension travel in off-road situations.
This system is controlled by the SWAY BAR switch
located on the instrument panel (to the left of the steering
column).