Lane Change Assist; Lights-On Reminder; High/Low Beam Switch; Flash-To-Pass - Jeep 2016 Wrangler Owner's Manual

NOTE:
• If either light remains on and does not flash, or there is
a very fast flash rate, check for a defective outside light
bulb. If an indicator fails to light when the lever is
moved, it would suggest that the indicator bulb is
defective.
• A tone will chime if the turn signals are left on for more
than 1 mile (2 km).

Lane Change Assist

Tap the lever up or down once, without moving beyond
the detent, and the turn signal (right or left) will flash
three times then automatically turn off.

Lights-On Reminder

If the headlights or parking lights are left on after the
ignition is turned OFF, a chime will sound to alert the
driver when the driver's door is opened.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 171

High/Low Beam Switch

Push the multifunction lever away from you to switch
the headlights to high beam. Pull the lever toward you, to
switch the headlights back to low beam.

Flash-To-Pass

You can signal another vehicle with your headlights by
lightly pulling the multifunction lever toward you. This
will turn on the high beams headlights until the lever is
released.

Front Fog Lights

The front fog light switch is located on the multi-
function lever. To activate the front fog lights, turn
on the parking or low beam headlights and pull out the
end of the lever.
3