Traction Control System (Tcs) - Jeep 2016 Wrangler Owner's Manual

• If disabling HSA using Uconnect Settings, refer to
"Uconnect Settings" in "Understanding Your Instru-
ment Panel" for further information.
For vehicles not equipped with the EVIC, perform the
following steps:
1. Center the steering wheel (front wheels pointing
straight forward).
2. Shift the transmission into PARK.
3. Apply the parking brake.
4. Start the engine.
5. Rotate the steering wheel slightly more than one-half
turn to the left.
6. Push the "ESC Off" button located in the lower switch
bank below the climate control four times within
twenty seconds. The "ESC Off Indicator Light" should
turn on and turn off two times.
7. Rotate the steering wheel back to center and then an
additional slighty more than one-half turn to the right.
8. Turn the ignition switch to the OFF position and then
back to the ON position. If the sequence was com-
pleted properly, the "ESC Off Indicator Light" will
blink several times to confirm HSA is disabled.
9. Repeat these steps if you want to return this feature to
its previous setting.

Traction Control System (TCS)

This system monitors the amount of wheel spin of each of
the driven wheels. If wheel spin is detected, the TCS may
apply brake pressure to the spinning wheel(s) and/or
reduce engine power to provide enhanced acceleration
and stability. A feature of the TCS, Brake Limited Differ-
ential (BLD), functions similar to a limited slip differen-
tial and controls the wheel spin across a driven axle. If
one wheel on a driven axle is spinning faster than the
STARTING AND OPERATING 487
5