Jeep 2016 Wrangler Owner's Manual page 500

498 STARTING AND OPERATING
However, the driver can override HDC operation by
applying the brake to slow the vehicle down below the
HDC control speed. If more speed is desired during HDC
control, the accelerator pedal will increase vehicle speed
in the usual manner. When either the brake or the
accelerator is released, HDC will control the vehicle at the
original set speed.
Enabling HDC
1. Shift the transfer case into 4WD LOW range. Refer to
"Four-Wheel Drive Operation" in "Starting and Oper-
ating" for further information.
2. Push the "Hill Descent" button. The "Hill Descent
Control Indicator Light" in the instrument cluster will
turn on solid.
NOTE:
• If the transfer case is not in 4WD LOW range, the
"Hill Descent Control Indicator Light" will flash for
five seconds and HDC will not be enabled.
• If the ESC senses that the brakes are overheating the
"Hill Descent Control Indicator Light" will flash for
five seconds and HDC will become deactivated until
the brakes have cooled.
Disabling HDC
Push the "Hill Descent" button or shift the transfer case
out of 4WD LOW range. The "Hill Descent Control
Indicator" light in the instrument cluster will turn off.