Adding Washer Fluid; Maintaining Your Vehicle - Jeep 2016 Wrangler Owner's Manual

Hide thumbs Also See for 2016 Wrangler:

Table of Contents

Installing The Rear Wiper

1. Insert the wiper blade pivot pin into the opening on

the end of the wiper arm. Grab the bottom end of the

wiper arm with one hand, and press the wiper blade

flush with the wiper arm until it snaps into place.

2. Install wiper assembly back on the wiper stud at it's

original position and gently tighten nut.

3. Lower the wiper blade onto the glass and snap the

wiper arm pivot cap back into place.

Adding Washer Fluid

The fluid reservoir for the windshield washers and the

rear window washer (if equipped) is shared. The fluid

reservoir is located in the engine compartment. Be sure to

check the fluid level at regular intervals. Fill the reservoir

with windshield washer solvent only (not radiator anti-

freeze). When refilling the washer fluid reservoir, take

some washer fluid and apply it to a cloth or towel and

wipe clean the wiper blades; this will help blade perfor-

To prevent freeze-up of your windshield washer system

in cold weather, select a solution or mixture that meets or

exceeds the temperature range of your climate. This

rating information can be found on most washer fluid

Commercial windshield washer solvents are flam-

mable. They could ignite and burn you. Care must be

exercised when filling or working around the washer

Table of Contents