Jeep 2016 Wrangler Owner's Manual page 129

Call Termination
To end a call in progress:
1. Momentarily push the Phone
• Only the active call(s) will be terminated and if there
is a call on hold, it will become the new active call. If
the active call is terminated by the phone far end, a
call on hold may not become active automatically.
This is cell phone-dependent.
2. To bring the call back from hold, push and hold the Phone
button until you hear a single beep.
Redial
To redial the last number called from your mobile phone
using Voice Command:
1. Push the Phone button to begin.
2. After the "Ready" prompt and the following beep, say
"Redial."
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 127
• The Uconnect Phone will call the last number that
NOTE: This may not be the last number dialed from the
button.
Uconnect Phone.
Call Continuation
Call continuation is the progression of a phone call on the
Uconnect Phone after the vehicle ignition has been
switched to OFF. Call continuation functionality avail-
able on the vehicle can be any one of three types:
1. After the ignition is switched to OFF, a call can
was dialed from your mobile phone.
continue on the Uconnect Phone either until the call
ends, or until the vehicle battery condition dictates
cessation of the call on the Uconnect Phone and
transfer of the call to the mobile phone.
3