Electronic Roll Mitigation (Erm) - Jeep 2016 Wrangler Owner's Manual

NOTE:
• The "ESC Activation/Malfunction Indicator Light"
and the "ESC OFF Indicator Light" come on momen-
tarily each time the ignition switch is turned ON.
• Each time the ignition is turned ON, the ESC system
will be ON even if it was turned off previously.
• The ESC system will make buzzing or clicking sounds
when it is active. This is normal; the sounds will stop
when ESC becomes inactive following the maneuver
that caused the ESC activation.
The "ESC OFF Indicator Light" indicates the
customer has elected to have the Electronic
Stability Control (ESC) in a reduced mode.

Electronic Roll Mitigation (ERM)

This system anticipates the potential for wheel lift by
monitoring the driver's steering wheel input and the
speed of the vehicle. When ERM determines that the rate
of change of the steering wheel angle and vehicle's speed
are sufficient to potentially cause wheel lift, it then
applies the appropriate brake and may also reduce
engine power to lessen the chance that wheel lift will
occur. ERM can only reduce the chance of wheel lift
occurring during severe or evasive driving maneuvers; it
cannot prevent wheel lift due to other factors, such as
road conditions, leaving the roadway, or striking objects
or other vehicles.
NOTE: ERM is disabled anytime the ESC is in "Full Off"
mode (if equipped). Refer to "Electronic Stability Control
(ESC)" in this section for a complete explanation of the
available ESC modes.
STARTING AND OPERATING 495
5