Using The Auto Take-Up Reel Unit; Media Loading And Take-Up - Epson SureColor F7170 User Manual

Important:
To continue printing after cutting, do not rewind the media past the cutter groove (on the
pressure roller side).
If the leading edge of the media is curled, stop rewinding before the media reaches the inner
side of the front cover.
Note:
If you are using the auto take-up reel unit, set the Auto switch on the auto take-up reel unit to Off
before using the Manual switch to position the media over the cutting groove.
Removing Media
You can now remove the media from the roll holders. To remove the media, reverse the
steps you followed to load it. See the section beginning with "Loading Media" on page 31.

Using the Auto Take-up Reel Unit

Media Loading and Take-Up

The auto take-up reel unit automatically takes up media as it is printed, improving the
efficiency of unmanned operation.
The auto take-up reel unit for this printer can take-up media in either of the following
directions.
Printed side out
Take-up with the printed side out places the printed surface on the outside of the roll.
Take-up with the printed side in places the printed surface on the inside of the roll.
Printed side in
Basic Operations 48