Epson SureColor F7170 User Manual page 19

3 Media info
If a media setting bank number created with this printer is selected as the print media, the number (from 1 to 30) will be
displayed. When RIP Settings is selected, 0 will be displayed.
The selected platen gap is shown as follows.
1.5
2.0
2.5
The media remaining is not displayed if Off is selected for Remaining Setup in the Media Remaining menu.
See "The Media Setup Menu" on page 119.
4 Chip unit status
The display changes as shown below when an error is detected in the installed chip unit.
Normal Warning or error
1 Status indicators
The chip unit status is indicated as follows.
No error. Ready to print.
An error occurred. Check the message on the screen, and clear the error
The chip unit could not be recognized or it is not compatible with the printer. Or, the slider is not
locked. Check the on-screen message.
The chip unit requires replacement. Replace the chip unit with one from a new ink pack. As it gets
closer to time to replace the chip unit,
2 Ink color codes
BK: Black
Y: Yellow
M: Magenta
C: Cyan
will begin to flash.
Introduction 19