Feed Adjustment - Epson SureColor F7170 User Manual

Note:
To rewind the media, press the u button. Stop rewinding before the media is past the cutter
groove (on the pressure roller side).
If the leading edge of the media is curled, stop rewinding before the media reaches the
inner side of the front cover.
12. When the final color has been configured, the printer returns to a ready state.

Feed Adjustment

Feed Adjustment is used to correct banding (horizontal banding, lines, or strips of uneven
color).
Two methods are available:
❏ Visually inspect prints and enter a correction by hand.
❏ Enter a correction during printing and inspect the results.
Notes on correct adjustment:
The condition of media is important for correct Feed Adjustment.
Observe the following points when loading media.
❏ Feed Adjustment varies with the media used. Load the media for which feed
adjustment is required under the same conditions as the actual print job. For example,
if you are using the Auto Take-up Reel Unit for printing, the Auto Take-up Reel Unit
should also be used for feed adjustment.
❏ We recommend performing adjustment again in the following cases, even if the media
has been adjusted.
❏ When the media type is the same but the width is different.
❏ When the Feeding Tension and Take-up Tension have been changed.
❏ When Media Suction has been changed.
❏ Pull the media to the prescribed position before performing Feed Adjustment. Correct
adjustment may not be possible if the media is not pulled sufficiently because the
condition of the leading edge of the media may worsen due to waves or other issues.
See "Loading and Exchanging Media" on page 30.
Basic Operations 76