Using The Auto Take-Up Reel Unit; Attaching The Roll Core - Epson SC-S60600 Series Operator's Manual

SC-S80600 Series/SC-S80600L Series/SC-S60600 Series/SC-S60600L Series/SC-S40600 Series Operator's Guide
c
Important:
❏ Do not use the media edge plates with
media that is 0.4 mm or thicker. The
media edge plates could touch and
damage the print head.
❏ Always position the plates so that the edges
of the media are at the centers of the round
holes. Incorrect positioning causes
banding (horizontal banding, tint
unevenness, or stripes) during printing.
❏ Move the media edge plates to the left and
right edges of the platen when they are not
in use.
❏ Do not use the media edge plates if the
sides of the printed media are smudged or
torn.
V
Using the Auto Take-up
Reel Unit
The Auto Take-up Reel Unit automatically takes up
media as it is printed. This improves the efficiency of
unmanned operation.
The Auto Take-up Reel Unit for this printer can take up
media in either of the following directions.
Printed side out
Taking-up with printed side out places the printed
surface on the outside of the roll.
Basic Operations
Printed side in
14
Taking-up with printed side in places the printed
surface on the inside of the roll.
You can check the procedure in a video on YouTube.
"Video Manuals" on page 4
U
Caution:
❏ Follow the instructions in the manual when
loading media or roll cores or removing the
take-up roll.
Dropping media, roll cores, or take-up rolls
could result in injury.
❏ Be sure that your hands or hair do not get
caught in the Media Feeding Unit or Auto
Take-up Reel Unit while it is operating.
Failure to observe this precaution could result
in injury.

Attaching the Roll Core

Preparing
Use a roll core that is longer than the width of the
media.
This allows the media to be taken up without protruding
from the core.
Prepare the supplied paper tape.
We recommend this method for attaching media to the
roll core due to the following advantages.
❏ It allows you to prevent misalignment of the roll at
the left and the right edges, and to prevent the media
from moving around, which provides a stable
printing length for print jobs.
❏ Media is not wasted.